Yakima Cargo Box Hanger Manual De Instrucciones

Do not exceed
hanger weight limit
of 200 lbs.
end cap (2x)
Bracket (2x)
Be sure all hardware is secured according
to instructions. attachment hardware can
loosen over time. Check before each use, and
tighten if necessary.
this product is covered by YaKima's "love it till You leave it" limited lifetime Warranty
to obtain a copy of this warranty, go online to www.yakima.com
or email us at yakwarranty@yakima.com or call (888) 925-4621
IMPORTANT WARNING: It is critical that all YAKIMA products and accessories be properly and securely attached. Improper attachment could result
in an accident, and could cause serious bodily injury or death to you or to others. You are responsible for securing the unit and accessories, checking
the attachments prior to use, and periodically inspecting the products for adjustment, wear, and damage. Therefore, you must read and understand
all of the instructions and cautions supplied with your YAKIMA product prior to installation or use. If you do not understand all of the instructions and
cautions, or if you have no mechanical experience and are not thoroughly familiar with the installation procedures, you should have the product installed
by a professional installer such as a licensed contractor.
K E E P T H E S E I N S T R U C T I O N S
1033379A-1/6
Cargo Box HaNgEr
Attach brackets to wood wall studs 32" apart (minimum 16").
If attaching to concrete or masonry, use YAKIMA Anchor Kit #05111.
Do not attach to sheet rock or plywood; there will not be enough
Bar (1x)
waSher (4x)
Lag BoLt (4x)
Set Screw (2x)
stability to safely use this product.
tooLS required:
• 7/16" wrench or socket
with driver
• 3/16" drill bit
• power drill (or hand
drill)
• tape measure
• Small blade screwdriver
• Stud finder
• Level (optional)
• eye protection
assistance or replacement parts
Contact your dealer or call (888) 925-4621
Monday through Friday, 7:00 aM to 5:00 pM, pST
Part #1033379 Rev A