Yakima FlipSide 4 Manual De Instrucciones página 2

Install tongue to mast
Read and remove
"Important Warning" tag.
• Insert mast
Install bolt, and washer.
Use this hole.
For 1-1/4" hItches: remove the 2" hItch adapter, and sleeve.
For 2" hItches: proceed to next step.
Remove the hex
bolt from the
adapter using hex
wrench.
1033438J-2/18
If the bushing slides
out during installation,
replace as shown with
• Lay mast
assembly
down flat
on a clean
non abrasive
surface.
through tongue.
the lip side up.
Put pivot
plate in
place.
• IMPORTANT: Pivot plate must fit over
step on axle.
• Install locking bolt, passing through
large washer.
Bolt cannot be adjusted after adhesive
patch sets. Patch sets quickly!
FULLY TIGHTEN with the wrench until
very snug.
IMPORTANT: You should
not be able to pivot
mast without the tongue
mounted in hitch receiver.
Remove the sleeve
from the tongue.
Remove the adapter
from the tongue.