DART Controls 250G CONTROL Serie Manual De Instrucciones página 6

250G SERIES CHASSIS HOOK-UP DIAGRAM
* Used for shunt wound motors only! No connection is made to these terminals when using permanent magnet motors.
250G SERIES ENCLOSED HOOK-UP DIAGRAM
Min
Inhibit
P2
Pin
P1
-1 -2 -3
chassis
ground
Endplate with holes for 1/2" NPT conduit
* Used for shunt wound motors only! No connection is made to
these terminals when using permanent magnet motors.
Min Max Accel
Inhibit
P2
Pin
orange white
red
P1
-1 -2 -3
armature
I.R. Cur.
Max Accel Comp Lim.
-4 -5 -6 -7 -8 -9 -10 -11
field*
motor
armature ac input
I.R. Cur.
Comp Lim.
Customer Installed
Speedpot
(factory provides 8"
leads)
-4 -5 -6 -7 -8 -9 -10 -11
- -
field* ac input
motor chassis
ground
WIPER (red)
LO (orange)
DPST SWITCH
(black)
(white
(white)
or yellow)
(black
or brown)
In the 250G enclosure kit you will find 2 endplates, a cover
assembly (containing speedpot, DPST switch, gasket and
wiring), and 8 screws. Install both endplates using (4) #5
screws, and the cover assembly, using (4) #6 screws. Before
screwing down cover assembly, route wiring through conduit
holes in endplate by terminal strip.
5
HI (white)
SPEEDPOT
INSIDE OF COVER