Attaching The Handbike Batec Electric; Detaching The Handbike Batec Electric; Using The Handbike Batec Electric Mini - BATEC MINI 2 Manual De Usuario

• hen lifting the HANDBIKE BATEC ELECTRIC, e recommend removing
the weight as indicated in section 3.10 and the battery as per section
4.9.1.
• hen transporting the HANDBIKE BATEC ELECTRIC in the boot of a
vehicle, e recommend leaving it attached to a heelchair henever
possible.
The BATEC HANDBIKE is not designed to be used as a means of trans-
port inside a vehicle.
The HANDBIKE BATEC ELECTRIC ELECTRIC should be stored in a cool,
dry place, protected from direct sunlight and rain. It should not be
ept out of use for more than t o months.

4.4. ATTACHING THE HANDBIKE BATEC ELECTRIC

• Step 1: Get in front of the HANDBIKE BATEC ELECTRIC, ith the han-
dlebar centred in front of the wheelchair, with the brake on.
14a, 14b)
• Step 2: Grab the HANDBIKE BATEC ELECTRIC by the handlebar and
pull it to ards you, rolling the frame stand until the detaching ramp
on the anchoring bar touches the front axle of the bar on the heel-
chair.
( ee fig. 15)
• Step : Tip the handlebar, lifting the front
HANDBIKE BATEC ELECTRIC to ards you.
has passed the front axle of the bar on the heelchair, let go of the
handlebar and put the front wheel back on the ground.
• Step : Ta e o the bra e on the
the HANDBIKE BATEC ELECTRIC handlebar to ma e sure the front
axle is securely in place.
• Step : Push the handle until it clic s, so that both the heels on the
HANDBIKE BATEC ELECTRIC stand frame and the front heels on the
heelchair are o the ground. Your HANDBIKE BATEC ELECTRIC is no
attached.
( ee fig. 17)
– 24 –
( ee fig.
heel, hile pulling the
hen the detaching ramp
( ee fig. 16a, 16b)
heelchair and push gently on

4.5. DETACHING THE HANDBIKE BATEC ELECTRIC

• Step 1: Ma e sure your HANDBIKE BATEC ELECTRIC is s itched o .
( ee fig. 18)
• Step 2: Push the anchor lever for ard
until you feel it come free. Don t let go of the lever and set the HAND-
BIKE BATEC ELECTRIC on the ground. Advice: lean your torso back to
ta e eight o the lever. This ill ma e it much easier to detach the
HANDBIKE BATEC ELECTRIC.
( ee fig. 19)
• Step : Tilt the handlebar, lifting the front heel, hile you push the
HANDBIKE BATEC ELECTRIC a ay from you.
• Step : hen the detaching ramp has gone over the front axle of
the wheelchair bar, let go of the handlebar and set the front wheel
do n again. Your HANDBIKE BATEC ELECTRIC is no detached.
fig. 21)
ADVICE
Practice attaching and detaching your HANDBIKE BATEC ELECTRIC
calmly and you ll see that, in just a fe
automatic.
4.6. USING THE HANDBIKE BATEC ELECTRIC MINI 2 / ELECTRIC 2
(RAPID 2) / SCRAMBLER 2 CONTROLS
• You can find out the meaning of all the symbols used on the controls
of the BATEC ELECTRIC HANDBIKE in Figure 58.
• Turn on: Turn the key on the right side of the battery clockwise to the
ON position. It ill do a system chec : don t start using your HAND-
BIKE BATEC ELECTRIC until it has finished ith the system chec and
all the lights are on.
( ee fig. 22)
– 25 –
ith the palm of your hand
( ee fig. 20)
(See
ee s of use, it ill become