BATEC MINI 2 Manual De Usuario página 53

Checking tyre pressure:
Ma e sure the tyre pressure is as recommended for each model and
that there are no irregularities on the surface.
Cleaning t e HANDBIKE BATEC ELECTRIC
Clean the frame ith soap and
er non-abrasive cleaning agent. Dry it carefully. Never use a pressure
washer to clean it.
Disinfecting the HANDBIKE BATEC ELECTRIC
To disinfect the HANDBIKE BATEC ELECTRIC, follow the steps below:
- Use a hydro-alcoholic sanitiser and a cloth.
et the cloth ith a generous amount of sanitiser.
Rub the cloth over any surfaces that come in contact ith the user:
handlebars, buttons, display panel and detaching lever.
- Leave to air dry.
IMPORTANT!
Sand and salt ater can damage some parts of the HANDBIKE BATEC
ELECTRIC after prolonged contact. Clean it after use in these conditions.
Cleaning front and rear wheels:
Ma e sure the front heel and rear heels turn freely and eliminate
any dirt.
Checking brakes:
Ma e sure that hen you squeeze the bra e levers, both have su -
cient contact ith the disc for e ective bra ing.
– 46 –
arm ater. Use car soap or anoth-
Greasing cables and c ains
Apply a drop of grease or light coat of Teflon spray to the cable con-
necting levers and to chains, after removing the old grease. After ap-
plying, remove any excess grease.
Greasing t e transmission mec anism
Apply a drop of grease or light coat of Teflon spray to the transmission
mechanism, after removing the old grease. After applying, remove any
excess grease.
Having HANDBIKE BATEC ELECTRIC serviced by an aut orised distributor
The recommended preventive maintenance and any repairs to your
BATEC ELECTRIC HANDBIKE must be done by a company authorised
by BATEC MOBILITY.
Replacing tyres and inner tubes:
Before installing a ne inner tube, chec the base of the rim and in-
side all of the tyre to remove any foreign bodies and, if necessary,
clean ell. Chec the conditions of the rim tape, particularly around
the valve hole. Only strong, properly placed rim tape can provide long
term protection against damage to the inner tube caused by burrs
and sharp spoke heads.
Before inflating the inner tube, chec the hole tube to ma e sure it
hasn t got stuc bet een the tyre and the rim. Carefully pull on the
valve and extract it for optimal installation.
Reusing t e BATEC ELECTRIC HANDBIKE
The BATEC ELECTRIC HANDBIKE can be reused. If you would like to
reuse it, please contact the distributor where you purchased it and
they will take care of sending the unit to be reused to the BATEC MO-
– 47 –