Publicidad
EN
3.2 WATER FLOW DELAY TIME ADJUSTMENT
The faucet activates or deactivates when the hand is detected for at least 0.5 sec. (default setting). This
time can be changed for installation requirements or user prefrerences.
This adjustment is only possible within the first 2 minutes after power supply connection
1
Unplug and plug the power
supply. Within the first 2 minutes,
proceed with the following steps.
4
When the red LED of sensor starts
to blink, remove hand. The water
flow will stop, if it was open.
7
x2
< 2 cm
The faucet starts water flow and
the LED blinks 2 times per sec.
for 5 sec. within those 5 sec. pla-
ce hand closer than 2 cm. The
LED stops blinking and water flow
stops. Remove hand before 3 sec.
10
Level 3
0.75 s.
< 2 cm
The LED blinks 3 times per sec. for
5 sec. To set Level 3 (0.75 sec.),
place hand closer to 2 cm. from
sensor. If this is not the desired
adjustment, do not place hand.
2
The LED blinks one time. Wait 5
sec. to start the adjustment pro-
cess.
5
After 3 sec. the faucet starts wa-
ter flow and the LED blinks 1 time
per sec. during 5 sec. Do not pla-
ce hand in fornt of sensor.
8
Level 2
0.25 s.
The LED blinks 1 time per sec. for
5 sec. To set Level 1 (0.25 sec.),
place hand closer to 2 cm. from
sensor. If this is not the desired ad-
justment, do not place hand.
11
Level 4
1 s.
x3
The LED blinks 4 times per sec.
for 5 sec. To set Level 4 (1 sec.),
place hand closer to 2 cm. from
sensor. If this is not the desired
adjustment, do not place hand.
x1
x1
x1
< 2 cm
x4
< 2 cm
11
3
< 2 cm
Place hand in fornt of the sensor
closer than 2cm. for 5 sec. re-
gardless of water flow .
6
The faucet closes the water flow
and the LED stops blinkining for
3 sec.
9
Level 2
0.5 s.
< 2 cm
The LED blinks 2 times per sec.
for 5 sec. To set Level 2 (0.5 sec.),
place hand closer to 2 cm. from
sensor. If this is not the desired ad-
justment, do not place hand.
x2
Publicidad
