EN
3.3 TIMEOUT ADJUSTMENT (AUTOSTOP)
The faucet deactivates the water flow automatically after 60 sec. (default setting). This time can be
changed for installation requirements or user prefrerences.
Ajuste sólo posible durante los primeros 2 minutos tras la conexión eléctrica
1
Unplug and plug the
power supply. Within the
first 2 minutes, proceed
with the following steps.
5
After 3 sec. the faucet starts wa-
ter flow and the LED blinks 1 time
per sec. during 5 sec. Do not pla-
ce hand in fornt of sensor.
8
The faucet stops water flow and
the LED stops blinking for 3 sec.
11
Nivel 2
30 s.
< 2 cm
The LED blinks 2 times per sec.
for 5 sec. To set Level 2 (30 sec.),
place hand closer than 2 cm from
sensor. If this is not the desired
adjustment, do not place hand.
2
x1
The LED blinks one time.
Wait 5 sec. to start the
adjustment process.
6
x1
The faucet closes the water flow
and the LED stops blinkining for 3
sec.
9
The faucet starts water flow and the
LED blinks 3 times per sec. for 5
sec. within those 5 sec. place hand
closer than 2 cm. The LED will stop
blinking and water flow closes. Re-
move hand before 3 sec.
12
Nivel 3
60 s.
x2
The LED blinks 3 times per sec. for
5 sec. To set Level 3 (60 sec.), place
hand closer than 2 cm from sensor.
If this is not the desired adjustment,
do not place hand.
3
< 2 cm
Place hand in fornt of the
sensor closer than 2cm.
for 5 sec. regardless of
water flow .
x3
< 2 cm
x3
< 2 cm
13
4
When the red LED of
sensor starts to blink,
remove hand. The water
flow will stop, if it was
open.
7
The faucet restarts the water flow
and the LED blinks 2 times per sec.
for 5 sec. Do not place hand.
10
Nivel 1
10 s.
< 2 cm
The LED blinks 1 time per sec.
for 5 sec. To set Level 1 (10 sec.),
place hand closer than 2 cm from
sensor. If this is not the desired ad-
justment, do not place hand.
13
Nivel 4
120 s.
< 2 cm
The LED blinks 4 times per sec.
for 5 sec. To set Level 4 (120 sec.),
place hand closer to 2 cm. from
sensor. If this is not the desired ad-
justment, do not place hand.
x2
x1
x4