Troubleshooting - Envirolite Easy-UP EV40543BMJ Instrucciones De Instalación

NM cable
Junction Box
Spring-loaded
wing
9. Continue inserting the fixture into the hole, while continuing to squeeze
the spring-loaded wings. When the wings reach the hole edge, release
them and push up the fixture until both wings flip down onto the ceiling
surface. (Fig. 5)
Spring-loaded
wing
Ceiling
For a complete list of compatible dimmers, please look up the item number
listed on the cover of this instruction manual at www.envirolite-LED.com.
FIVE-YEAR LIMITED WARRANTY

Envirolite warrants this product to be free from defects in material and
workmanship for five years from the original date of purchase by the
consumer. This warranty is limited to the counter replacement at the time
of purchase, with the original purchase receipt. Envirolite
liable for the loss or damage of any kind, incidental or consequential
damages of any kind, whether based on warranty contract or negligence,
and arising in connection with the sale, use or repair of the product
claimed to be defective. Some states do not allow the exclusion or
limitation of incidental or consequential damages so the above limitation
may not apply to you. This warranty gives you specific legal rights and
you may also have other rights, which vary from state to state. Misuse,
accident, improper installation or maintenance will also void the warranty.
Hole
Fig. 4
DIMMING

ALL RIGHTS RESERVED. COPYRIGHT  Envirolite 2018
-90
SYMPTOM
Lights flicker
during
dimming.
Fuse blows or
circuit breaker
trips when
light is turned
on.
Fig. 5
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
will not be
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiver antenna.
•
Increase the separation between the equipment and receiver.
•
Install the product onto on a circuit different from that to which the
receiver is connected.
•
Consult with the dealer or an experienced radio/TV technician for
help.
CAUTION: Any changes made to the electronics circuit will void this
equipment's compliance with Part 15 of the FCC Rules and should not be
operated.
LIGHT DISTRIBUTION MAP
-/+180
-150
-120
70
140
-60
210
280
-30
350
0

TROUBLESHOOTING

ACTION
Check if dimmer being
used is compatible
dimmer list from
"DIMMING" section
Check wire
connections inside the
junction box.
.
150
120
90
60
30
SOLUTION
If dimmer is not on list, replace
it with a dimmer from the list.
If wiring connections are loose
or disconnected, redo
connections. Make sure there
are no exposed wire
conductors.
If wiring connections are good,
the trim may be defective and
will need to be replaced.