REPA MILLENNIUM V8 BASIC PLUS AS Manual De Instrucciones página 17

With the buttons
Press again the button
flashing.
With the buttons
Confirm with the button
3) SOFTENING WATER QUANTITY PROGRAMMING
DEPENDING ON THE HARDNESS OF THE INCOMING WATER
Press and hold the buttons at the same time
Press the button and the symbol for the wrench will light up on the display
Press 4 times until the display shows the Default digits:
MILLENNIUM 8: 0.55 / MILLENNIUM 12: 1.10
warning
NOTE
Notice: these values are indicative with reference to an input water hardness of 35 °F.
If the input water hardness value is different from the standard value (35 °F), a different programming can be carried out by
following the instructions below:
Press the button and on the display the digit on the left will start flashing.
With the 2 buttons
possession.
WATER HARDNESS IN °F (FRENCH DEGREES)
15-20 °F
20-25 °F
25-30 °F
DEFAULT VALUE 30-35 °F
35-40 °F
40-45 °F
45-50 °F
Confirm with the button
set the desired regeneration hours.
and the second 2 digits of the display representing the regeneration minutes 02 - 00 will start
set the desired regeneration minutes.
and wait 60 seconds until you hear the sound of the beep and it indicates the key pad is locked.
it is possible to modify the value by entering the data corresponding to the model in your
MODEL MILLENNIUM 8 (M
1.00
0.80
0.65
0.55
0.50
0.43
0.40
and wait 60 seconds until you hear a beep and the key pad is locked.
for 5 seconds until you hear the sound and the unlocked key appears.
)
3
.
MODEL MILLENNIUM 12 (M
2.00
1.60
1.30
1.10
1.00
0.85
0.80
)
3
17