The thermosealing machine ULTIseal BASE740 has been tried and tested in the factory.
Remove the packing and install the apparatus using the following instructions:
1. Install the machine on a smooth flat surface with a remaining space of a least 50-80 mm. on all sides.
2. Do not install the machine close to a sink or similar area to avoid contact with water and possible electrical
short circuits.
3. Keep away from heat sources
4. Install the machine in a ventilated area.
5. Ensure that the electrical cable is not folded up and freely reaches the electrical socket.
6. The unit must be placed so that the plug is accessible.
7. Insert the plug and the machine is ready for use.
2.1.1 - Instructions for wall mounting
1. Unit does not come with wall mounting screws or wall hangers, please use fixtures suitable for the
wall.
2. Please mount in a safe place away from electrical wiring or plumbing in the wall.
3. Follow the directions in the image below to mount the unit to the wall.
CHAPTER 2
2.1 - INSTALLATION
Screw
Use a wall
with a cap
hanger
of mm.9,5
suitable to
the wall
surface
6
ULTIseal BASE740_EN Rev 2021/01