Testing And Commissioning - Ravelli Chronos Manual De Operación Y Mantenimiento

Adjustment of the door
The door may "hang" a little over time. This can be solved by adjusting the adjustment screw of the door upwards using an 8 mm
open-end spanner. The adjustment screw is placed at the top of the hinge as shown below.

Testing and commissioning

The insert must be put into service before it is put into service, and the following elements must be tested for operation:
connection to the smoke evacuation system; check that all materials for the construction of the smoke duct, flue, chimney, are compli-
ant and suitable for use.
The test is positive only when all the operating phases are completed without any anomalies being detected.
Connection of the smoke connection
Scan 1005 Justering af låge
EMNE:
The insert is factory set for a superior smoke outlet. Mount the fitting on the insert, once placed in the cassette.
If the radiation plate was removed before installation, remember to put it back in place before putting the combustion chamber back
AREAL:
into the cassette.
Mount the 3 x 8 mm gasket on the edge of the flange of the fitting. Secure the fitting with the flange nuts.
The gasket
Montage røgstuds
Scan 1003
NAVN: EMNE:
MATERIALE:
Use and maintenance manual Chronos, Zeus, Ercole e Ermes
Scan 1003
NAVN:
MATERIALE:
DIMENSION:
91005032
TG.NR:
N/A 22-05-2018
VÆGT: DATO: C:\Working Folder\Designs\Scan 1003\91003012.idw SIGN:
STI:
N/A
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
NB: The chimney must be mounted with the 1 m rigid pipe supplied.
91003014
TG.NR:
N/A DATO: 16-11-2018
VÆGT: SIGN:
Justering af låge
EMNE:
ken
Radiation plate
Montage røgstuds
NAVN: Scan 1003 EMNE:
N/A
MATERIALE: VÆGT:
DIMENSION: AREAL: N/A
C:\Working Folder\Designs\Scan 1003\91003014.idw
STI:
KEN
N/A
VÆGT:
N/A
AREAL:
4 x flange nuts M6
TG.NR: 91003014
16-11-2018 KEN
DATO: SIGN:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
Rev.1 12/12/2019
Page 77
91003
TG.NR:
k
22-10-2018
DATO: SIGN:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©