Krieger HC10 Manual Del Usuario página 10

Installation and connection of hc10
Remove the front cover from the display by inserting a small screwdriver in the square hole
on top of the thermostat. At the same time, carefully lift the front cover outwards. Then
remove the frame.
Connect wires and sensors to hc10 in accordance with the diagram.
Connection must be made by an authorised electrician.
Important! See section, Starting up underfloor heating with hc10, before turning on the
power.
Replace the frame and press on the cover. Activate the lock with a click.
13) Floor sensor status
‹ Press [·]
‡ FL : - -, sensor not connected, broken or short-circuited
‡ FL : HI, other errors
10