Krieger HC10 Manual Del Usuario página 8

4.4) Deactivating program/time zone
‹ Press [P]
‡ PROGRAM will flash
‹ Press [Ç] or [Å] until you get to the program you wish to deactivate; the display will flash
‹ Press [·]
‡ The temperature will flash
‹ Press [π]
‡ PROGRAM will flash
‹ Press [OK]
The selected program-time zone has been deactivated
4.5) Activating program/time zone
‹ Press [P]
‡ PROGRAM will flash
‹ Press [Ç] or [Å] until you get to the program you wish to activate; the display will flash.
‹ Press [·]
‡ Lines will flash
‹ Press [π]
‡ PROGRAM will flash
‹ Press [OK]
The selected program-time zone has been activated
5) Changing max. and min. limits for monitoring floor temperature
This function is only active, if 10hc has been selected to operate with combined room and
floor sensor (CO)
Changing the factory-set values of max. 27°C and min. 15°C
‹ Press [P]
‡ PROGRAM will flash
‹ Press [Ç] or [Å] until program H or L flashes on the display
‹ Press [·]
‡ The temperature will flash
‹ Use [Ç] or [Å] to set the temperature.
‹ Press [OK]
‡ The selected PROGRAM will flash
‹ Use [Ç] or [Å] to select the program which you now wish to change
or
‹ Exit by pressing [OK] for 2 seconds
6) Changing from Quickstart to Night and day setback
Change from Quickstart program to Night and day setback program
‹ Press [P]
‡ PROGRAM will flash
‹ Press [OK]
hc10 will now operate night and day setback
The previously set times and temperatures in Night and day setback are saved.
7) Changing from Night and day setback to Quickstart
Change from Night and day setback program to Quickstart program
‹ Press [·]
‡ FL: - - flashes
‹ Press [OK]
hc10 will now operate with Quickstart.
The previously set times and temperatures in Night and day setback are not deleted on
changing to Quickstart.
8) Switching between display of actual room temperature and desired
temperature
‹ Simultaneously press [·]+[OK]. Hold them in for min. 3 seconds
‡ This will switch the display between actual and desired room temperature
Switch back in the same way.
‹ Simultaneously press [·]+[OK]. Hold them in for min. 3 seconds
‡ The display will switch back again.
8