Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
the back of the tool which in
the long-term can be serious
consequences such as a
system blockage at the front or
a break in the heating system.
In this event:
- Remove the nozzle, beware
with the device being hot.
- Place the tool on its
stand. Leave it plugged
in and heated. Purge
the tool by letting the
hot glue flow out under
gravity, onto a disposable
support (container, paper,
cardboard,..).
- Insert a new glue stick,
pushing lightly on the trigger.
- Pull the trigger a few times,
to make sure that the old
glue has been completely
cleared and the tool has
been completely purged.
- Replace the nozzle with a
new one.
• In any case, you should never:
- Force the trigger before the
tool has heated up to its
working temperature
- Push hard on the glue stick,
never attempt to remove it from
the back.
• Repair work on the glue gun
should be carried out by
qualified staff only.
• If the power supply cable is
damaged it must be replaced
by the manufacturer, the
manufacturer's after sales
service or a similarly qualified
person in order to avoid any
danger.
Electric wiring diagram
PTC Heater
ON/OFF Switch
Warranty and repairs under
warranty
Warranty period: This product
is guaranteed for 2 years from the
date of purchase (original sales
receipt acting as proof).
Warranty conditions: All points
mentioned in this document must
have been fully adhered to.
Warranty repairs: The Esselte-
Rapid After-Sales Service is the
only approved service to carry out
warranty repairs on this tool.
In the event of a claim under
the warranty:
1 Return the product in its original
packaging to the shop or outlet
that supplied you with this
product,
2 Accompany the returned
product with the original dated
receipt.
Any breach of one of these
points would prevent
consideration by RAPID under
the manufacturer's warranty.
AC 220~240V
7
Publicidad
Tabla de contenido
