Steren MUL-100 Manual De Instrucciones página 11

Current Measurement
1. Set the rotary knob to the desired AC (A ~)
position. The hook arms will measure the AC
amps (~) that circulate through the conductor.
2. When the number "1" appears on the LCD
screen, it means that there is an overrange
situation. Select a higher range.
Voltage Measurement
1. Connect the black lead to the COM input and
the red lead to the VΩ input
2. Set the selection knob to the desired range
(V - - -) or VAC (~) and connect the measuring
C
tips.
3. When the number "1" appears on the LCD
M
screen, there is an overrange situation. Select a
Y higher range.
CM
MY
Measurement of resistance
CY
1. Connect the black lead to the COM input and
the red lead to the VΩ input.
CMY
K
2. Set the selection knob to the desired position
and connect the measuring tips.
If the measured resistance exceeds the
maximum value of the selected range, the LCD
will display the number "1" indicating over
range.
3. When measuring a resistor in the circuits, you
must be careful that they are out of power and
the capacitors are completely discharged.
MUL-100-V1.0-instr.pdf 11 22/11/16 10:32
CAT III 600V
COM EXT
CAT II
750V
1000V
MAX