Brake Pedal; Start The Engine - Kärcher B 300 RI LPG Manual De Instrucciones

ATTENTION
Check the braking effect of the parking brake now and
then; the braking effect is OK if the vehicle can be stopped
on an incline of 16°.
6.1.4 Opening the gas supply (gas engine)
6.1.5

Start the engine

ATTENTION

Ensure that the brushes are raised up.

All four control levers must be in middle position.

Do not press the accelerator pedal when starting up!
Sit on the driver's seat.

Activate parking brake.

Set motor speed to approx. 75% of the maximum

speed.
Insert the ignition key into the ignition switch.

Turn the ignition key to ignition on (position I).

Turn the ignition key to start motor (position II) and hold

it until the motor has started (max. 10 seconds).
Release the ignition key. The ignition key turns to posi-

tion I.
6.1.6 Driving
DANGER
Risk of accident, risk of injury!

The flashing beacon must be switched on during oper-
ation with rotating side brushes.
DANGER
Risk of accident!

It is prohibited to drive with the waste container raised!
CAUTION
Risk of damage!

Let the motor warm up sufficiently prior to driving or
loading the vehicle.

Always press the accelerator pedal carefully and slow-
ly. Do not jerkily change from reverse to forward drive
or vice versa.
Release parking brake.

Press accelerator pedal down slowly.

Control the driving direction with the steering wheel.

6.1.6.1 Drive forward
Press slowly the accelerator pedal "forward".

6.1.6.2 Reverse drive
DANGER
Risk of injury!

When reversing, there must not be any risk for third par-
ties, have somebody marshal the driver if necessary.
Press slowly the accelerator pedal "reverse".

6.1.3

Brake pedal

The brake pedal activates the brake system of the rear
wheels. The correct setting of the brakes takes place auto-
matically, no adjustment work is required.
Actuation takes place hydraulically, therefore always make
sure that there is a sufficient amount of brake fluid in the
storage tank.
1 Gas withdrawal valve
Open the gas drawing valve by turning it in anti-clock-

wise direction.
At ambient temperatures below 0°C (32 °F): Allow the

motor to warm up at a low motor speed before begin-
ning work.
Note
If the motor does not start, repeat the start-up process.
6.1.6.3 Driving method
The travel speed is steplessly regulated with the accel-
–
erator pedal.
Avoid sudden operation of the accelerator pedal as this
–
may damage the hydraulic system.
6.1.6.4 Braking / stopping
Release the drive pedal, the machine brakes automat-

ically and stops.
For a stronger braking effect or in case of an emergen-

cy, actuate the brake pedal.
6.1.6.5 Driving over obstacles
ATTENTION
Objects or loose obstacles may not be run over or pushed.
Stationary obstacles may be driven over only when a

suitable ramp is used.
14
-
EN 15