Emptying The Waste Water Tank - Kärcher B 300 RI LPG Manual De Instrucciones

6.2.5 End wet cleaning process
Stop the machine.

Switch off the brushes.

Note
The brushes lift up.
Raise the side scrubbing deck.

Switch off the water pump.

Switch off suction blower.

Note
The suction bar lifts up.
6.2.6

Emptying the waste Water tank

18
6.2.4.1 Adjusting the brush contact pressure
1 Brush contact pressure (rotary potentiometer)
To increase the brush contact pressure - rotate poten-

tiometer clockwise
To decrease the brush contact pressure - rotate poten-

tiometer anti-clockwise
After cleaning

Empty the dirt water reservoir.

Empty waste container.

(see Chapter "Sweeping | Emptying the waste contain-
er")
Clean the device, waste water tank, fresh water tank,

suction bar and spray nozzles.
(see Chapter "Cleaning").
WARNING
Risk of personal injury or damage!

Always apply and secure the safety support with the tilt-
ing device raised.
CAUTION
Please observe the local provisions regarding the waste-
water treatment.

Empty the waste water tank only via a suitable collec-
tion unit.
ATTENTION
If the waste water tank is full, the suction turbine switches
off and the indicator lamp "Waste water tank full" lights up.
1 Safety support
2 waste water tank
3 Dirt water discharge hose
4 Cleaning flap
Depending on the type of dirt, the cleaning flap must be
opened regularly and the tank flushed.
Empty waste container.

(see Chapter "Sweeping | Emptying the waste contain-
er")
Afterwards, secure the waste container with the safety

support.
17
-
EN