Fuel Information; Filling - Solo MASTER 452 Manual Original

Fuel information ; Filling

8. Fuel information

The engine of your motorized mistblower is a high
performance 2-cycle engine and has to be
operated with a fuel/oil mix or with a special, pre-
mixed fuel for 2-cycle engines available from
specialized dealers.
The fuel mix must be formed from the following
components:
 Lead-free regular petrol or lead-free super petrol
with a minimum octane number of 92 RON.
 Branded 2-stroke engine oil corresponding to
the standard ISO-L-EGD or JASO FD
Recommendation:
Use the "SOLO Profi 2-stroke engine oil" at a
mixing ratio of oil:petrol of 1:50 (2 %).
Store the fuel mix no longer than 3 weeks.
Mix table for fuel mix:
Oil:petrol ratio = 1:50 (2 %)
Branded 2-stroke engine oil
20 ml
40 ml
100 ml
200 ml
Instead of a self-produced fuel mix, you may also
use a pre-mixed special fuel mix for two-stroke
motors.
Recommendation:
Use the special fuel mix of the brand "Aspen
2-stroke".
The special fuel manufacturer's information must
be observed.

Smoking or open flame is prohibited

Allow engine to cool before re-fuelling

Fuel may contain solvent-like substances.
Avoid skin and eye contact with mineral
products. Wear gloves while refueling.
Frequently change and clean protective
clothing. Do not inhale fuel vapors.

Do not spill fuel or oil. In case of spillage,
immediately wipe off mistblower. Do not allow
fuel mix to contact clothing. If fuel mix is spilled
on clothing, change clothing immediately.

Ensure fuel or oil do not contaminate soil
(environmental protection). Always use a
suitable protective soil cover.

Do not re-fuel in unventilated rooms. Fuel
vapors collect at ground level (danger of
explosion).

Transport and store fuel and oil only in
approved and clearly marked containers.
ENGLISH 8
Children should have no access to fuel or oil.

Ensure you do not inhale exhaust fumes while
using the machine. The use of the motorized
mistblower is prohibited in closed rooms.
The handling of fuel requires caution and
consideration. It is imperative that all safety
instructions are observed! Only refuel when the
engine has been stopped!

Clean the area around filler inlet before
refueling.

Remove tank lid and fill fuel mix up to the lower
edge of the filler neck. Do not overfill. If
possible, always use a fuel funnel with filter.

Fill in card fully to avoid spilling of fuel or oil.

Replace and secure fuel tank lid.
When handling the spraying agents, always follow
the safety instructions of these operating
instructions (pay special attention to section 4.6)
Petrol
and the information provided by the manufacturer
1 l of the particular spraying agent.
2 l
Spraying agent volume:
5 l
Mix the spraying agents according to the
instructions provided by the manufacturer of the
10 l
spraying agent. Choose the appropriate volume
according to requirements.
Mixing spraying agents:
Only mix spraying agents out in the open. Never do
this inside living spaces, stables or in storage
spaces that are used for food or animal feed.
Never mix the spraying agent directly in the
spraying agent tank.
Spraying agents in powder form:
 Mix the spraying agent in a separate container,
not in the spraying agent tank.
 Ensure that the mixture is thoroughly mixed
before pouring it into the spraying agent tank.
Liquid spraying agents:
 Fill 1/4 of the spraying agent tank with clean
water.
 Then pre-mix the spraying agent with clean
water in a separate container according to the
instructions provided by the manufacturer of the
spraying agent.
 Pour the pre-mixed spraying agent into the
spraying agent tank.
 Top up with the required amount of clean water
according to the manufacturer's instructions.

9. Filling