Canopy Assembly; Blade Assembly - Craftmade Garrick Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Locate 15 blade attachment screw/washers
in hardware pack. Slide blade through one
of the narrow, rectangular openings on
motor housing, aligning holes in blade with
holes in blade arm (located on the
underside of the motor housing)--refer to
drawing at right. [Be sure to note label on
blade indicating THIS SIDE UP and turn
blade so that label faces up.] Insert 3 blade
attachment screws/washers with fingers
first and then tighten screws securely with a
Phillips screwdriver. Repeat procedure for
each remaining blade.
Note: Tighten blade attachment screws
twice a year.
receiver
canopy
screw
blade attachment
screws/washers
page 8
antenna
hanging bracket
screw
canopy cover
motor housing
blade