Kohler STERLING 6300 Serie Guia De Instalacion página 12

Wall
Jamb
Strike Jamb
Wall Jamb
8. Install the Door Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with the tools or any
hard objects. Do not set the unframed tempered glass directly on the floor.
Slide the hinge jamb into the other wall jamb. Each slot in the hinge jamb will slide over the screw
body and fit between the clamp and wall jamb.
Tighten the four flathead screws, using the 3/32" hex wrench, until snug.
9. Adjust and Secure the Door
The glass on the door should be aligned evenly with the back edge of the strike seal. The edge of
the glass should be 3/16" (5 mm) from the strike jamb.
1019156-2-H
Adjust the top edge of
the door glass to be
even with the top edge
of the strike seal.
3/16"
(5 mm)
Glass
Strike Seal
Latch
Glass
Strike Seal
3/16"
(5 mm)
Flathead Screw
Top View
Hinge Jamb
12
Hinge Jamb
Wall Jamb
Wall Jamb
Clamp
Sterling