Troubleshooting - Jacuzzi ARGA Manual De Instrucciones

Troubleshooting

the Swirlpool® /
sanitisation function
does not start
the Swirlpool® /
sanitisation function
stops of its own accord
The flow of jets has decreased
The display does not re-
ceive commands
W
e always recommend carefully reading the manual; in the instance that there is an is-
sue, refer to the following guide.
- Check that the main switch is on.
- Be sure to press the relative key and then lift the finger; to activate the sanitisation, press
and hold the button for approx. 4 seconds.
- Insufficient water level (when attempting to activate the function, the jets and display
will flash).
Fill the tub to the level indicated (please see the "Swirlpool® function" section) and press the
button again.
- Check that there is no blackout.
- The function is pre-set to approximately 20 minutes, after which the cycle stops on its
own.To start it again, simply press the start button again.
- Be sure to press the relative key and then lift the finger.
- If the water falls below the minimum level (e.g. because the drain is open), the pump
stops (the jets and display will flash).
Fill the tub to the level indicated (please see the "Preliminary checksl" section) and press the
button again.
- In the case of sanitisation, the Jets and the display flash rapidly for about 5 minutes
(after this time, the flashing continues slowly).
Restore the water level within 5 minutes from notification (the pump will activate and the
cycle continues); where this is not completed, the cycle is definitely interrupted.
- Clean the suction nozzle as shown in the "Maintenance" chapter.
- If two keys are accidentally pressed at the same time, no function is activated. You will
need to wait three seconds before giving a new command.
- If the display is covered by a layer of water, it may not receive commands. Just wipe the
water off with the palm of your hand and wait about 3 seconds before giving another
command.
29