I Troubleshooting - Jacuzzi Maxi Manual De Instalación

I TROUBLESHOOTING

(please also see the chapter on "WARNING MESSAGES")
PROBLEM
Dirty Water
Excessive water
consumption
Low water flow rate
from the hydromassage
nozzles
No water flow
Noisy pump and motor
PROBABLE CAUSE
Filter(s) clogged or blocked
Insufficient water treatment
High content of solids in the
water
Improper maintenance
Leak in the feed or drain lines,
or at joints
Excessive evaporation and/or
water overflow
Water level low
Filter(s) clogged or blocked
Adjustable jets partially closed
Suction or drain pipes
partially clogged
Pump operates at a
speed that is too low
Pump gaskets worn or
damaged
Voltage too low
No power
Pump off
Motor does not turn on
Main switch turned off
Residual current operated circuit breaker (RCCB) has tripped Reset the RCCB
Faulty pump or motor
Filter(s) clogged
SOLUTION
Clean or replace the filter(s)
See the chapter on "Water
Treatment"
See the instructions regarding
Maintenance
Repair the leak
Use the spa cover
Set a lower water temperature set point
Fill to the level mark
on the skimmer
Clean or replace the filter(s)
Open the jets
*
*
*
Contact an electrician or
the electric power utility
Move the main switch
to the ON position
Press the button
Check the motor connection
Turn on the switch
*
Clean the filter(s)
41