NAMCO GATOR PANIC Manual Del Operador página 49

Note: The PC Boards are sensitive to static electricity. Ensure anti-static procedures
are followed when handling the PC Boards.
1. Remove the Alligator Assy.
2. Remove the pozi head screw (M4x12), with countersunk washer, and remove the
nylon cable clamp.
3. Remove the 4off pozi head screws (M5x20), with body stoppers and remove the
Body.
4. Unsolder the wires from the Sensor Pc Board. (Note the positions of each wire so
that they are refitted correctly on the new PC Board).
5. Remove the 2off pozi flange head screws (M3x6) and remove the Sensor PC
Board complete with sensor nut.
6. Reassemble in reverse order.
Nylon Clamp
Countersunk
washer
Surface mounted side
Tie-wrap
Sensor PC Board
Plastic Tube
Pozi flange screw
(M3x6)
(See 6-5 page 47)
Pozi head screw
(M4x12)
Page 49
Pozi head screw
(M5x20)
Body
Pozi head screw
Body Stopper
Chassis
(M5x20)