1.
Remove the Drive Assy.
2.
Unsolder the wires from the Sensor Pc Board. (Note the positions of each wire so
that they are refitted correctly on the new PC Board).
3.
Remove 2off pozi flange screw (M3x6) and remove the Sensor PC Board.
4.
Refit the new Sensor PC Board and resolder the wires.
5.
Reassemble into the cabinet.
Pozi flange screw
(M3x6)
Sensor PC Board
(Rear)
Wire Connections
Orange (x2)
Light Blue (x1)
Brown (x2)
Sensor PC Board
(Rear)
(see 6-10 page 52)
Pozi flange screw
(M3x6)
Orange
Light Blue
Brown
Sensor Pc Board
(Front)
Orange (x1)
Green/Yellow (x1)
Brown (x1)
Page 53
Sensor PC Board
(Front)
+5v
SIG
GND