Section 3 Set Up; Grounding; Components And Controls - Togo POWER GG1000 Manual Del Propietário

Section 3 Set Up

IMPORTANT
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
WARNING
Operation of this equipment may create sparks that
can start fires around dry vegetation. A spark
arrestor may be required. The operator should
contact local fire agencies for laws or regulations
relating to fire prevention requirements.

Grounding

1. The Generator must be properly grounded in
accordance with all relevant electrical codes and
standards before operation. Have the unit grounded
by a qualified electrician if you are not qualified to
do so.
2. To ground the Generator, connect a #10 AWG
grounding wire (not included) from the Grounding
Terminal on the side of the unit to a grounding rod
(not included). The grounding rod must be an
earth-driven copper or brass rod (electrode) which
can adequately ground the Generator.
3. Refer to local regulations for ground source
information.
Owner's Manual for Petrol Generator
TABLE 1. Components and Controls
1
2
3
4
5
6
1. Grounding Terminal - connect grounding wires here
to properly ground the generator.
2. 120 Volt AC Receptacle - for connecting electrical
devices that run on 120V, 60 Hz, single phase, AC
current.
3. Circuit Reset Button - Reset button that protects the
generator from outlet overload
4. Engine Switch - to start/stop engine.
5. Choke Lever - adjusts the amount of air let into the
engine during startup.
6. Air Cleaner- a removable, cleanable, sponge-like
element that filters the air entering the engine.
7. Carrying Handle - for easy transport of the generator
(installed by user)
8. Fuel Tank - 1.05 gallon capacity.
9. Spark Plug - ignites engine.
10. Fuel Cap - access to the fuel tank for adding fuel.
11. Fuel Valve - allows fuel to enter engine from the fuel
tank.
12. Recoil Starter - pull-cord for starting engine
7
8
9
10
11
12
5