Castor Wheels Replacement - Pegasolift T14 Guía Para El Uso Y El Mantenimiento

OTHER PERIODICAL CONTROLS OTHER PERIODICAL CONTROLS
Every 500 hours check if there are not damages or burns on the resorts pushing the Every 500 hours check if there are not damages or burns on the resorts pushing the
brushes or on the rotor collector. brushes or on the rotor collector.
Every 1000 hours check if the bearings in double scheme with grease at high Every 1000 hours check if the bearings in double scheme with grease at high
temperature have not leakages; check the perfect fastening of the fittings, the good temperature have not leakages; check the perfect fastening of the fittings, the good
fastening of electrical contacts and that the insulation against the mass is over 2 fastening of electrical contacts and that the insulation against the mass is over 2
Megohm. Megohm.
3 3 4 4
1 1
3 3
TRACTION WHEEL MAINTENANCE TRACTION WHEEL MAINTENANCE
REPLACE OF THE FRONT ROLLERS REPLACE OF THE FRONT ROLLERS
To replace the front roller is necessary to: To replace the front roller is necessary to:
1) Lifting the forks at the maximum height until the 1) Lifting the forks at the maximum height until the
roller isn't as indicate. roller isn't as indicate.
2) Disconnect the start key (see page 12 2) Disconnect the start key (see page 12
"Instruments" n° 1). "Instruments" n° 1).
3) Put the truck on safe supports. 3) Put the truck on safe supports.
4) Extract the retaining ring (4) and remove the 4) Extract the retaining ring (4) and remove the
rotation pin (4) to release the roller (2). rotation pin (4) to release the roller (2).
5) Replace the damaged roller, insert the distance 5) Replace the damaged roller, insert the distance
pieces and the rotation pin (4) fixing it with the pieces and the rotation pin (4) fixing it with the
retaining ring (4). retaining ring (4).
2 2

CASTOR WHEELS REPLACEMENT

CASTOR WHEELS REPLACEMENT
Also the castor wheel is subject to wear itself. Also the castor wheel is subject to wear itself.
For replacement is necessary operate as follows: For replacement is necessary operate as follows:
1) Disconnect the start key (reference page 12 1) Disconnect the start key (reference page 12
"instruments" no. 1). "instruments" no. 1).
2) Put the stacker on safe supports 2) Put the stacker on safe supports
3) Remove the electronic components cover 3) Remove the electronic components cover
4) Remove the wheel (2) unscrewing the self-locking 4) Remove the wheel (2) unscrewing the self-locking
nuts (1). nuts (1).
5) Put at its place the new wheel paying attention to 5) Put at its place the new wheel paying attention to
the orientation of the fixing flange. the orientation of the fixing flange.
2 2
C 23 55
55