KTM Power Parts PILLION ERGO Guia De Informacion página 6

6
- Remove cover .
NOTE
To do this, press the holding lugs together from the inside and push
the cover outwards.
- Mount heater switch .
Holding lugs engage.
- Plug in connector for heater switch
- Position activated charcoal fi lter
- Mount screws and tighten to 8 Nm.
Make sure that the wiring harness
- Plug connector for the passenger seat heating
ger seat (included).
- Mount passenger seat (see Owner's Manual).
Route the cable properly and secure with a cable tie. Ensure
that the cables are not kinked or pinched. Check the cable rout-
ing to ensure that there is no chafi ng.
Final steps
- Mount the front rider's seat (see Owner's Manual).
(small white connector).
.
remains free.
into the passen-