Installation; Selection Of Installation Equipment - MiLECTRIC ECM-3F Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Some pans make
crackling or clicking
noises.

8. Installation

8.1 Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated
work surface material (Wood and similar fibrous or hygroscopic material shall not be used as work surface
material unless impregnated) to avoid the electrical shock and larger deformation caused by the heat
radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop
should be at least 3mm.
L(mm)
W(mm)
H(mm)
590
520
55
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet and outlet
are not blocked. Ensure the ceramic cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at
least 760mm.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
D(mm)
A(mm)
51
560+4
+1
This is normal for cookware and
does not indicate a fault.
B(mm)
X(mm)
490+4
50 mini
+1
18
F(mm)
3 mini

Publicidad

Tabla de contenido
loading

Tabla de contenido