Battery Cabinet Installation; Preparation; Transportation; Mechanical Check - Tripp-Lite BP240V65 Manual Del Propietário

3. Battery Cabinet Installation

3.1 Preparation

• At your site, prepare to off-load the battery cabinet from the delivery truck and transport it to the final installation location.
Consider both the packaged weight and dimensions.
• Make sure the floor can support the load of the specific battery cabinet being installed. The battery cabinet must be installed
in a structurally sound area with a level floor that is able to bear the weight of the battery cabinet and other equipment that
will be installed nearby.
• Draw a wiring schematic representing the cables connected between the battery cabinet's output terminal blocks and any
external disconnect device, junction box and/or load/rectifier.
• If you plan to store the battery cabinet for an extended period before or after installation, follow the instructions in
section 9. Storage and Service.

3.2 Transportation

1. Inspect the shipping container(s) for visible damage (do not remove the stretch wrap around the unit until it has been
transported to the final installation location). Confirm that the model name and rating match the unit you ordered. If
you determine the unit has been damaged during shipping or if anything appears to be missing, contact Tripp Lite for
assistance. Do not attempt to use the unit if it has been damaged or mishandled.
2. Do not attempt to move or unpack the battery cabinet without assistance. Use appropriate handling equipment rated to
bear the weight and bulk of the battery cabinet, such as freight elevators, pallet jacks and forklifts. (Fully extend forks under
load. Spread forks to maximum possible width under load. Lift cabinet from bottom only. Wear safety shoes.) Confirm load
limits for freight elevators, handling equipment and floors along the transport route are not exceeded by the combined
weight of the packaged battery cabinet, handling equipment and personnel. Confirm that the packaged unit will pass
through any doorways along the intended route.
3. The battery cabinet is secured with stretch wrap to protect it during shipping and movement within a facility. Remove the
stretch wrap from the battery cabinet when the unit is in the final installation location—not before.

3.3 Mechanical Check

While the assembled cabinet battery system is still on the shipping pallet, inspect all sides for impact or other damage.
1. Open the front door of the battery cabinet.
2. Confirm none of the internal parts (batteries, terminal blocks, circuit breaker and other parts) have been damaged.
3. Note the individual battery model number and terminal type shown in section 8. Specifications.
4. Use insulated tools to tighten all battery terminal connections to the recommended torque shown in the table in section
6.3 Power Cables.
5. Use insulated tools to tighten the cables from the positive and negative output terminals at the end batteries to the
circuit breaker.
Read Section 2 – Important Safety
Instructions Before Installation
7