Battery Cabinet Installation; Preparation; Transportation - Tripp-Lite BP240V370 Manual Del Propietário

3. Battery Cabinet Installation

Read Section 2 – Important Safety Instructions

3.1 Preparation

• At your site, prepare to off-load the battery cabinet from the delivery truck and
transport it to the final installation location. Consider both the packaged weight and
dimensions.
• Make sure the floor can support the load of the specific battery cabinet being installed.
The battery cabinet must be installed in a structurally sound area with a level floor
that is able to bear the weight of the battery cabinet and other equipment that will be
installed nearby.
• Draw a wiring schematic representing the cables connected between the battery
cabinet's output terminal blocks and any external disconnect device, junction box and/
or load/rectifier.
• If you plan to store the battery cabinet for an extended period before or after
installation, follow the instructions in Section 8. Storage and Service.

3.2 Transportation

1. Inspect the shipping container(s) for visible damage (do not remove the stretch wrap
around the unit until it has been transported to the final installation location). Confirm
that the model name and rating match the unit you ordered. If you determine the
unit has been damaged during shipping or if anything appears to be missing, contact
Tripp Lite for assistance. Do not attempt to use the unit if it has been damaged or
mishandled.
2. Do not attempt to move or unpack the battery cabinet without assistance. Use
appropriate handling equipment rated to bear the weight and bulk of the battery
cabinet, such as freight elevators, pallet jacks and forklifts. (Fully extend forks under
load. Spread forks to maximum possible width under load. Lift cabinet from bottom
only. Wear safety shoes.) Confirm load limits for freight elevators, handling equipment
and floors along the transport route are not exceed by the combined weight of the
packaged battery cabinet, handling equipment and personnel. Confirm that the
packaged unit will pass through any doorways along the intended route.
3. The battery cabinet is secured with stretch wrap to protect it during shipping and
movement within a facility. Remove the stretch wrap from the battery cabinet when
the unit is in the final installation location—not before.
18-07-363-933856.indb 7
Before Installation
7
8/1/2018 4:55:36 PM