Mr Handsfree Blue Smart Manual Del Usuario página 8

Important!
• Make sure that all the necessary cables, the handsfree unit and/or the external speaker are well installed be-
fore connecting the Blue Smart to the power supply of the car.
• During operation, do not attempt to access the speaker unit and the sockets of the speaker unit.
• For disconnecting the Blue Smart, always disconnect the power supply first.
HANDSFREE UNIT (SM3)
Search for a location in your car where the handsfree unit fits and where it is comfortable for use. Make sure that the
location in your car where you would like to install your handsfree unit is free from dust and dirt.
We recommend mounting the handsfree unit at a less visible position in the car (See illustration above). However, make
sure that the unit can provide good acoustic, by directing the speaker in the opposite direction of the microphone and by
placing the unit at a distance of more than 1 meter from the microphone.
The handsfree unit can be fixed in 2 ways:
1. Under the dashboard or at any other place in the car using the installation screws.
2. Under the dashboard or at any other place in the car using the double-sided tape.
REMOTE CONTROL (RC1)
The remote control should be located so that it is within easy reach of the driver.
There are 2 possible locations for mounting the remote control unit (See illustration above):
1. On the console between the front seats using the double-sided tape.
2. On the dashboard using the double-sided tape.
Make sure that the location in your car where you would like to install your remote control is free from dust and dirt.
Make sure that the cable that comes out of the remote control unit is placed so that it will not be damaged (e.g. not laid
under car seats or over sharp edges).
MICROPHONE (M1)
Mount the microphone close to the user's head (30 cm is optimal) and place it so that it is directed towards the mouth.
Experience has shown that the best location is near the rearview mirror or to the left of the sun visor (See illustration
above). To avoid echo, it is recommended to have a minimum distance of 1 meter between the microphone and the
handsfree unit.
Make sure to mount the microphone so that it is not exposed to air streams from the vents. Do not lay the microphone cable
in the heating, ventilation or AC systems. Fix the microphone using Velcro.
CONNECTING TO THE POWER
There are 3 ways of connecting the Blue Smart to the car's electronic system:
1. Plug & drive connection: Via the adapter for the cigarette lighter (SC3) (Optional).
2. Built-in connection: Immediately to the car's electronic system via system cable SC2 (Optional).
The wires of cable SC2 are color-coded. They are listed in Table 1 in column A and each wire should be connected to
the corresponding item listed in column B.
GB - 5