RIDGID R4040 Manual Del Operador página 13

ASSEMBLY
INSTALLING WATER TRAY
See Figure 8 - 9.
 Place the water tray, with the pump and filter in place,
on a sturdy flat surface or on level ground.
 Attach the water hose to the pump elbow.
 Carefully lift the motor head and water tray frame
assembly over the water tray, as shown.
 Tilt the water tray frame and insert heavy duty tab into
the bar slot on water tray.
 Secure the water tray frame in place with latches on front
of the water tray.
RUBBER
BOOT
PUMP
POWER
CORD
WATER HOSE
PUMP ELBOW
BAR SLOT
 Connect the pump power cord to the motor head power
cord. Check that the rubber boot is pulled over cord
connection to help keep water off the plug.
NOTE: The pump turns on when the motor is turned on.
Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Rest power cord and water hose in the notches provided
on the water tray.
HEAVY DUTY
TAB
BAR SLOT
WATER
TRAY
13 — English
MOTOR HEAD
AND FRAME
ASSEMBLY
LATCHES
Fig. 9