Tips And Recommendations - SOMFY Sonesse 40 Zigbee Instrucciones

Sonesse® 40 Zigbee
2.3.2. Drive settings
• Once the Set&Go Connect Application is downloaded, open
the app and follow the instructions to set the drive.
• Once the drive is set, check the settings by pressing the
button on the motor head:
- To start the motorised product movement, briefly press
the button on the motor head.
- To stop the motorised product movement, briefly press
the button on the motor head.
- To move the motorised product in the opposite direction of the previous movement, briefly
press the button on the motor head again.
- To stop the motorised product movement, briefly press the button on the motor head, and
so on.
2.3.3. Network management
To join a network :
• Follow the instructions on the Set&Go Connect application,
• Press and hold the motor head programming button (≈ 7
seconds) until the product makes 2 back and forth movements
(the first feedback after 2 seconds and the second after 7
seconds).

2.4. TIPS AND RECOMMENDATIONS

2.4.1. Questions about the drive ?
Observations
The motorised product does
not operate.
The motorised product stops
too soon.
The red light of the remote
control lights up.
Copyright © 2018 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
Possible causes
The drive is powered off.
The remote control battery is
low.
The remote control is not
compatible or not programmed.
The thermal protection is
activated.
The motor is not linked to a
network.
The end limits are incorrectly
adjusted.
The motorised product has
exceeded recommended weight
limit.
There is a setting error.
0.5 sec 0.5 sec
a
=
b
=
7 sec 7 sec
Solutions
Turn on the drive.
Check the battery and replace it
if necessary.
Check the compatibility and
replace the remote control if
necessary.
Wait for the motor to cool
down.
Go to chapter 2.3.3. Network
management
Reset the end limits.
Replace the product.
Go to chapter 2.3.2. Drive
settings
EN
a
=
b
=
11