Changing The Master Code; Installing/Replacing The Battery; Programming The User Code; Changing The User Code - Arregui Perfect Manual De Instrucciones

Caja fuerte electrónica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note: For models that open with a key, it is necessary to
place it in the open position in order for the safe to open
when you enter the codes.

INSTALLING/REPLACING THE BATTERY

• The removable battery case is located beneath the keypad.
• Press the tabs inwards and move it downwards.
• Squeeze the latch and pull down on the battery holder..
• Disconnect the battery from the contacts.
• Remove the battery and replace it with a new one (6LF22 9V).
• Place the battery holder in its original position in the keypad.
1. OPENING AND CLOSING THE SAFE
• Press "ON". The safe will beep twice and the light will turn
green.
• Enter the master code (123456 by default) or the 6-to-8-
digit user code (this is not configured by default; to do so,
see "Programming the User Code).
• Press "ENTER". Once the light turns green you have
approximately 5 seconds to turn the handle clockwise and
open the safe.
To close the safe, simply close the door and turn the handle
anticlockwise.
If you enter an incorrect code 3 times in a row, the safe will be
blocked for 5 minutes. When this occurs, the light flashes red.
2. PROGRAMMING

2.1. CHANGING THE MASTER CODE

• Press «ON».
• Press «ENTER».
• Pulse «1».
• Press «ENTER».
• Enter the current master code and press "ENTER" (when
programming for the first time, the default master code is
123456).
• Enter the new master code (minimum of 6 and maximum of
8 digits) and press "ENTER".
• Enter the new master code again and press "ENTER".
• To check the new master code, press: "ON" > New master
code > "ENTER".
If the process has been completed successfully, the safe will
beep twice and the light will turn green.
If the process has not been completed successfully, the safe
will beep twice and the light will turn red. In this case, wait 10
seconds and then start the process again from the beginning.

2.2. PROGRAMMING THE USER CODE

(USING THE MASTER CODE)
• Press «ON».
• Press «ENTER».
• Press «2».
• Press «ENTER».
• Enter the current user code > "ENTER" > master code >
"ENTER".
• Enter the new user code > "ENTER".
• Enter the new user code again > "ENTER".
To check the new user code, press: "ON" > New user code >
"ENTER" and the safe should open.

2.3. CHANGING THE USER CODE

(WITHOUT THE MASTER CODE)
• Press «ON».
• Press «ENTER».
• Press «3».
• Press «ENTER».
• Enter the current user code and press "ENTER".
• Enter the new user code (minimum of 6 and maximum of 8
digits) and press "ENTER".
• Enter the new user code again and press "ENTER".
To check the new user code, press: "ON" > New user code >
"ENTER".
En

Publicidad

Tabla de contenido
loading

Tabla de contenido