Installation - Infiniton GASHQ4 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

IMPORTANT
: The gas cooker must be installed by a competent person to the relevant Gas Standards.
Please, ensure that, once the gas cooker is installed, it is easily accessible for the engineer in the event of a breakdown.
WHEN THE GAS COOKER IS FIRST INSTALLED
Once the gas cooker has been installed, it is important to remove any protective materials, which were put on in the factory.
Any gas installation must be carried out by a competent person.
Important: When installing the gas cooker above a built-in oven, the oven should be placed on two wooden strips; in the
case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back.
When installing on a built-in oven without forced ventilation, ensure that there are air inlets and outlets for ventilating the
interior of the cabinet adequately.
Gas Connection
A:
End of shaft with 1/2 BSP male thread
B:
Washer
C: Connector nut
D: Barb connector for hose (See Figure 17)
Figure 17
Cut Out dimensions
The dimensions of the cut-out are given in the diagram. (Dimensions are given in mm.)
835
Figure 18
Figure 19
Electrical connections
Any electrical work required to install this gas cooker should be carried out by a qualified electrician or competent person.
Check the last letter of your model to know the electrical supply type:A is for AC,D is for DC.
See PAGE 1 to check the electrical supply of your model
The GAS COOKER MUST BE EARTHED
If the hobs to be connected to a 110~240 V 50/60 Hz AC electrical supply.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the hobs rating label.
Ensure that the hobs supply cable does not come into contact with surfaces with temperatures higher than 50 deg. C.
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gg-419Gmci4Ggmci-421Gwg-420

Tabla de contenido