Maintenance, Cleaning And Care - Proxxon BS/E Manual Del Usario

Some types of wood or even varnish residues (or similar) can
generate harmful dusts while working. If you are unsure of
the harmlessness of your material to be ground, please wear
a dust protection mask! In any case, ensure your working
area is well ventilated while working!
1. Switch unit on at switch 2 (Fig. 2) and adjust the speed at
knob 1 in accordance with the operation.
2. The grinding surface 2 (Fig. 3) is particularly suitable for
processing plane surfaces. Curves are best processed
with grinding surface 1. Surface 3 is suitable for operati-
ons in narrow apertures and cavities.
High grinding performance is achieved not by applying
excessive pressure but by employing a correct and even belt
speed.
Replacing the grinding belt
Attention!
Disconnect from the mains before replacing the grinding
belt.
1. Depress tensioning roller 1 (Fig. 4) axially and remove
grinding belt from the drive roller (2).
2. First position new grinding belt around the tensioning rol-
ler (1). Then press the tensioning roller backwards and
position the belt over the drive roller (2).
Adjusting the grinding belt
The grinding belt must run in the vcentre of the tensioning
roller. If this is not the case, it must be readjusted.
Danger of injury!
1. Switch unit on
2. Select lowest speed
3. Turn adjusting screw 2 (Fig. 5) to left or right until the belt
runs in the centre of the tensioning roller (1).
Adjusting the grinding head
1. Switch unit off
2. Press retaining knob 1 (Fig. 6) in and adjust the grinding
head (2) to the desired angle.
3. Release retaining knob. The grinding head engages.
- 8 -
Danger
Note:
Danger!
Connecting the vacuum cleaner
1. Connect parts of the connection adapter 1 (Fig. 7).
The adapter parts can be connected in such a way that vacu-
um cleaner pipes of various diameters may be connected.
2. Insert vacuum cleaner hose (2) into the connection adap-
ter (1).

Maintenance, cleaning and care

Attention:
Disconnect the mains plug prior to every adjustment,
maintenance measure or repair!
Every device is dirtied by dust when working with wood.
Cleaning is therefore essential. To ensure a long service life,
however, the machine should be cleaned with a soft cloth or
brush after each use.
Mild soap or other suitable cleaning agent may be used in
this context. Solvents or cleaning agents containing alcohol
(e.g. petrol, cleaning alcohols, etc.) should be avoided, since
these can attack plastic casings.
The apertures required for cooling the motor must always be
kept free of dust and dirt.
Accessories
For more detailed information on accessories, please request
our device catalogue from the address specified on the last
page in the warranty information.
Please note in general:
Proxxon bits and cutters have been designed to work with
our machines, which makes them optimal for their use.
We will not assume any liability whatsoever for the safe and
proper function of our devices when using third-party bits
and cutters!
Service note
Please note:
The mains power input may only be replaced by our Proxxon
Service Department or a qualified specialist!
Disposal
Please do not dispose of the device in domestic waste! The
device contains valuable substances that can be recycled. If
you have any questions about this, please contact your local
waste management enterprise or other corresponding muni-
cipal facilities.
Note:
Note: