Troubleshooting; Product Maintenance - HAMPTON BAY 743-253 Manual De Instrucciones

TROUBLESHOOTING:

Lights will not turn on.
Bulb will not turn on.
Fuse blows or circuit
breaker trips when light is
turned on.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water,
never a solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit
breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean
cloth (use clean water, never a solvent) to wipe the interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth
to dust or wipe carefully.
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of five (5) years from date of purchase. This warranty applies only to
the original consumer purchaser and only to products used in normal use and service. If this
product is found to be defective, the manufacturer's only obligation, and your exclusive remedy, is
the repair or replacement of of the product at the manufacturer's discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect
or mishandling. This warranty shall not apply to any product that is found to have been
improperly installed, set-up, or used in any way not in accordance with the instructions supplied
with the product. This warranty shall not apply to a failure of the product as a result of an
accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not
relating to faulty material or workmanship. This warranty shall not apply to the finish on any
portion of the product, such as surface and/or weathering, as this is considered normal wear and
tear. The manufacturer does not warrant and specially disclaims any warranty, whether
expressed or implied, of fitness for a particular purpose, other than the warranty contained
herein. The manufacturer specifically disclaims any liability and shall not be liable for any
consequential or incidental loss or damage, including but not limited to any labor/expense
costs involved in the replacement or repair of said product.
Possible Cause
1. Power is off.
1. Bulb is burned out
2. Faulty wire connection.
3. Faulty switch.
1. Crossed wires or power wire is
grounding out.
LIMITED WARRANTY
Corrective Action
1. Make sure power supply is on.
1. Replace light bulb.
2. Check wiring.
3. Test or replace switch.
1. Check wire connections.
Page 9