Maintenance; Filter Replacement; Compressor Pump Oil Change - Ingersoll Rand SS3F2-GM Manual Del Propietario Con La Lista De Piezas

WARNING
Unplug the unit and release air pressure from the tank
before performing maintenance .
All compressed air systems contain maintenance
parts (e .g . lubricating oil, filters, separators) which are
periodically replaced . These used parts may be, or may
contain, substances that are regulated and must be
disposed of in accordance with local, state, and federal
laws and regulations .
Take note of the positions and locations of parts during
disassembly to make reassembly easier . The assembly
sequences and parts illustrated may differ for your
particular unit .
Follow engine owner's manual for engine maintenance
schedules and procedures .
Any service operations not included in this section
should be performed by an authorized service
representative .
ROUTINE MAINTENANCE SCHEDULE

•
Check lubricant level. Fill as needed.
• Drain receiver tank condensate. Open
the manual drain valve and collect and
Daily or
dispose of condensate accordingly.
Before
• Check for unusual noise and vibration.
Each
•
Ensure and covers are securely in place.
Operation
•
Ensure area around compressor is free
from rags, tools, debris, and flammable or
explosive materials.
•
Inspect air filter element. Clean or replace
Weekly
if necessary.
• Inspect for air leaks. Squirt soapy water
around joints during compressor
operation and watch for bubbles.
Monthly
•
Check tightness of screws and bolts.
Tighten as needed.
•
Clean exterior.
•
Change petroleum lubricant while
3/500 *
crankcase is warm.
•
Change synthetic lubricant while
crankcase is warm.
12/2000 *
•
Replace filter element.
22204861 Rev. C
RELEASED 26/Jan/2020 20:37:54 GMT

MAINTENANCE

NOTICE
NOTICE
NOTICE
NOTICE
* indicates months/operating hours, whichever occurs
first .

FILTER REPLACEMENT


1. Unscrew and remove the wing nut (A).
2. Remove the filter cover (B), baffle (C) and element (D)
from the base (E).
3. Install a new element and reassemble the filter assembly.
The air intake holes in the baffle and cover must be
staggered 180° . When reinstalling the assembly at the
inlet connection, ensure the intake hole in the cover is
on the bottom to minimize the entry of foreign matter
from the air .
Filter Replacement


COMPRESSOR PUMP OIL CHANGE

1. Remove the oil drain plug (A) and allow the lubricant to
drain into a suitable container.
2. Replace the oil drain plug.
3. Follow the filling procedures in OPERATION section.
COMPRESSOR PUMP OIL CHANGE

BELT ADJUSTMENT

CHECKING BELT TENSION - Check belt tension occasionally,
especially if looseness is suspected. A quick check to
determine if adjustment is proper may be made by observing
the slack side of the belt for a slight bow when the unit is
in operation. If a slight bow is evident, the belt is usually
adjusted satisfactorily.
TENSIONING BELTS - Belt tensioning can be achieved by
loosening the motor anchor screws, pushing the motor away
from the pump, and retightening the motor anchor screws.
The motor can be easily moved by placing a prying tool
beneath it A commercially available spreader or other belt
tensioning device can also be helpful should tensioning be
necessary.
NOTICE
EN