Cequent Performance Products 75699 Instrucciones De Instalación

Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75699F
Wrenches: 21mm
Note: Fasteners typical
both sides
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch
installation
1. Remove (4) existing M14 bolts (Do Not clean the threads). Retain bolt for reinstallation.
2. Raise hitch into position as shown and install fasteners as shown. If excess caulking on the
frame rail interferes with hitch installation lower hitch and scrape excess caulking for installation.
3. Tighten all fasteners to called-out torque specification
Tighten all M14 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2010, 2014 Cequent Performance Products –
Installation Instructions
Jeep Grand Cherokee
Excluding EcoDiesel Models
Fascia
Wiring Access Location: 2011-13 SUV 1, 2
Frame rails
Existing weldnut
both sides
Retain bolt for
reinstallation.
Sheet 1 of 3
Printed in Mexico
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Max Gross
Hitch type
Trailer WT (LB)
7500 (3405 Kg)
Weight Distributing
Weight Carrying
5000 (2270 Kg)
Ball Mount
2014- SUV 3, 4
Note: Uses all
existing Bolts
on Vehicle
75699N
Part Numbers:
75699
87595
44650
Max Tongue
WT (LB)
750 (341 Kg)
500 (227 Kg)
C
Accessory Rating
1-24-14 Rev. C
Form: F205 Rev A 5-6-05