vitapur VWD5446WV Manual De Uso Y Cuidado página 7

Cleaning the Condenser
Vacuum or sweep away the dust from the condenser coils at the back of the
dispenser. For best results, you can purchase a brush designed specifically
for this purpose from your local appliance store. This will improve cooling and
efficiency.
Draining the Reservoirs
Drain the reservoirs before and after cleaning, when going on long vacations or
if not using the dispenser for long periods of time.
IMPORTANT! Unplug the dispenser before performing this procedure.
Dispense hot water until temperature drops to a safe level to avoid the risk
of scalding.
1. Remove the water bottle.
2. Press both dispensing taps until water no longer comes out.
3. Place a bucket beneath the drain valve on the back of the dispenser.
4. Remove the cap and plug from the drain valve and let the water flow into the bucket. Replace the cap and plug.
(A screwdriver or coin can be used to help loosen the drain cap.)
IMPORTANT: Collect the water in a container, not the drip tray.
5. Replace the water bottle (see Installing the Water Bottle).
Cleaning the Inside of the Dispenser
To prevent mineral deposits that can affect the taste and flow of the water and to ensure proper product performance,
your water dispenser must cleaned every 4 months.
1. Unplug the power cord.
2. Remove the water bottle and bottle support collar.
3. Drain the reservoirs (see Draining the Reservoirs).
4. Pour a vitapur® water dispenser cleaner or a mixture 4 cups / 1L of
vinegar with 4 cups / 1 L of hot water into the reservoir and wait 20
minutes. If using a water dispenser cleaning solution, please follow the
manufacturer's instructions.
IMPORTANT: To avoid water overflow while cleaning the dispenser, always remove the bottle support collar
before pouring water or cleaning solution into the reservoir (see Figure A on pg. 2).
5. Press both dispensing buttons until water no longer comes out.
6. Drain the reservoirs.
IMPORTANT: Collect the water into a container, not the drip tray.
7. Rinse with clean water.
8. Replace the bottle support collar and the water bottle (see Installing the Water Bottle).
IMPORTANT: Drain approximately 4 glasses of water from each tap before initial use. This does not need to be
done with replacement bottles.
www.greenwayhp.com
6
Cleaning Kit
Available online at
5