Cleaning And Maintenance - vitapur VWD5446WV Manual De Uso Y Cuidado

present and/or low water levels are detected inside the internal water reservoir, activation/operation of the Kettle
Feature hot water heating system is not possible. Likewise, if the hot water heating system is operational and
water is being drawn simultaneously causing internal water levels to drop below the established minimal level set
point, hot water tank operation is automatically suspended. To reactivate the hot water heating system, you must
replenish your water supply.
NOTE: Operation of the cold water system is not affected by this safety feature.
Child Resistant Safety Switch
To prevent hot water from being dispensed accidentally and possible harming
a child, the hot water dispensing button can only be operated when the child
resistant safety switch is activated. To dispense hot water, push the child safety
switch sideways, (in the direction of the arrow located on the switch) from
right to left, then depress the hot water button until the desired amount of hot
water is dispensed. Upon releasing the hot water button, the child safety lock
automatically returns to the locked position.
DANGER: The hot water is heated to approximately 194˚ F / 90˚C. Temperatures above 125˚ F / 52˚ C can cause
severe burns from scalding. DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERvISION.

CLEANING AND MAINTENANCE

Like most appliances, your water dispenser requires periodic maintenance for maximum efficiency and performance and
must be cleaned on a regular basis (i.e. every 4 months). To maintain a hygienic environment within your water dispenser
and prevent potential formation (growth) of bacteria, we strongly recommend regular cleaning. A cleaning kit is available
through our Customer Service Department at 1-866-253-0447 or can be ordered on line at www.greenwayhp.com.
Cleaning Your Water Dispenser
IMPORTANT: Make sure you unplug the dispenser before performing any
of the following cleaning procedures.
Cleaning the Outside of the Water Dispenser
The outside of the dispenser can be wiped clean with a vitapur® water
dispenser cleaning solution or a mild soap and water mixture. Never use harsh
chemicals or abrasive cleaners. Rinse thoroughly with clean water and then dry
surfaces.
Cleaning the Drip Tray
To remove, take the grill off the tray and firmly lift the tray up, dislodging it from
the guides. Drain and clean.
The drip tray should be emptied and cleaned regularly to remove spotting and any
mineral deposits. Clean with vitapur® water dispenser cleaning solution or a mild
soap and water mixture. For tough deposits, add vinegar and let it soak until the
deposits come loose. Then wash, rinse and dry thoroughly. To replace, put the grill
back on the tray and slide the tray onto the guides (not dishwasher safe).
4
resistant
grill
drip
tray
5
Child
safety
switch
Condenser
coils
Drain
Valve