EAS ELECTRIC ECH R32 Serie Manual De Instalación Y Usuario página 72

Press the "▲" and "▼" buttons to set the
values and press "OK" button to save the
setting and return to the previous interface,or
press the "BACK" button to cancel the setting
and return to the previous interface. If there is
no operation in 60 seconds, the wired remote
controller will return to the home page.
◆
Set defrosting:
Press "▼" and "▲" buttons to select the "SET
DEFROSTING" in the "PROJECT MENU"
interface,and press the "OK" button to enter
the interface, The interface display is as
follows:
SET DEFROSTING
T_
T_FROST
DEFROST_
IN
35min 0℃
OK
Presss the"◄" and "►" buttons to select the
desired option, and press "▲" and "▼" buttons
to set the temperature and press the "OK"
button to save the setting and return to the
previous interface,or press the "BACK" button
to cancel the setting and return to the previous
interface. If there is no operation in 60
seconds, the wired remote controller will return
to the home page.
T_
FROST_
OUT
0℃
◆
Set heater:
Press "▼" and "▲" buttons to select the
"SET HEATER" in the "PROJECT MENU"
interface,and press the "OK" button to
enter the interface, If it is controlled by
single water pump.The interface display is
as follows:
SET HEATER
HEAT2(DISABLE)
OK
Select the"HEAT1",and press the "OK" button
to access the interface, The interface display is
as follows:
SET HEAT1
Temp_
ENABLE/
AuxHeat-
DISABLE
5℃
DISABLE
OK
16
HEAT1
Tw_
Heat1_ Heat1_
ON
ON
25℃ 45℃
V.1
Tw_
OFF