Use; Warranty; Maintenance Operations To Be Performed By The User - Cattini Oleopneumatica YAK 300 Manual Uso Y Mantenimiento

USE

Follow the safety rules given in this manual to the letter.
WARNING! Before operating the jack, open the cock
1. Position the jack beneath the support point indicated in the vehicle manufacturer's manual.
2. Press the raising button indicated on the control distributor to raise the load.
3. Position the handle in the housing on the motor, DWG. 11, and turn it anticlockwise to discharge the pressure
inside the jack and lower the load.
4. Press the lowering button indicated on the control distributor while the valve is kept open (point 4) to make the
pistons return fully.
5. After lifting the load, it is absolutely essential to rest it on appropriate support stands before performing any work
beneath it.
The manufacturer shall not be held liable for any damage to the lifted vehicle or other property, or for injuries,
caused by incorrect use of the jack.
After lifting the load, it is absolutely essential to rest it on appropriate support stands before performing any work
beneath it. REMEMBER! THE JACK IS A LIFTING DEVICE AND NOT A SUPPORT DEVICE!
- - The operator's employer shall provide the necessary training and supply the necessary information on pumping
and movement forces.
- Before working with the jack, it is advisable to perform a few operations with no load in order to acquire the sensitivity
necessary to work safely with the jack.
- When the jack is not in use, always keep the pistons lowered
IMPROPER USE
The air-hydraulic jack has been designed and manufactured to lift transport vehicles. Any other use of the jack which does
not conform to the safety standards outlined in this manual, for instance lifting and/or moving persons, is considered
absolutely improper.

WARRANTY

This jack is covered by a 12-month warranty starting from the date the jack leaves our factory unless the warranty has
been activated on-line; this covers all manufacturing defects but not transport expenses, defects caused by improper use
or damage suffered during transport. For more details please see the warranty card attached to this manual.

MAINTENANCE OPERATIONS TO BE PERFORMED BY THE USER

- To ensure a long life for your jack, it is advisable to clean the outside of the pistons every two weeks.
- Check the level of fluid in the tank at least twice a year
CHECKING THE HYDRAULIC FLUID LEVEL
IMPORTANT: the maximum quantity of hydraulic fluid contained in this jack is 1.4 L. Compatible fluid: ATF DEXRON IID
Please follow the steps listed here to check the hydraulic fluid level:
1. Bleed off the air (see procedure in the next section)
2. Position the jack, with its pistons lowered, in the horizontal position
3. Unscrew the screw POS. 25 A00348 POS. 25 A00348
4. If no hydraulic fluid comes out once the screw has been unscrewed, the level is too low. Top up the fluid in this case.
The level must be at the height of the small bolt on the side of the tank.
5. If hydraulic fluid does come out, let the excess quantity drain off until the correct level is reached (see point 4).
14
5 - A00563 5 - A00563
.
EN