Fitting The Accessories - SCOPREGA GE 20-2 Manual De Instrucciones

HOSE AND CORD STORAGE
• The 12Vdc cords and the air hose are located in the carry bag.
• The accessories like 110-240 Vac battery charger and cigarette plug are stored on the
upper compartment of the carry bag.

FITTING THE ACCESSORIES

• Your inflator is supplied with the standard tapered nozzles that are located inside the
upper compartment of the carry bag.
• Make sure that the Unit is OFF (no light on the gauge).
• Remove the hose from the storage location.
• Press the air hose clips to the port to inflate (OUT).
• Fit the air hose adaptor to the inflatable.
OPERATING THE INFLATOR
• To INFLATE Connect the tube to the outlet port. Set the pressure knob to the desired limit.
• Press the ON push button. The unit will start and the light on the gauge will turn GREEN.
The inflator will stop automatically when the inflatable reaches the set value.
• If the light on the gauge turns YELLOW press OFF and connect the inflator to a vehicle
plug or to an external battery via cable and alligator clips.
• If the light on the gauge turns RED press OFF and connect the inflator to an external
battery via cable and alligator clips.
WARNING
Make sure polarity is correct (Red to Positive).
With wrong polarity the Inflator WILL NOT START.
• Press the ON push button; the unit will Start and the light on the gauge will turn GREEN.
WARNING
Exercise with care when connecting the cord to batteries in order not to short the
battery with conducting materials such as rings, bracelets and keys. The battery or
conductor may overheat and cause burns.
WARNING
Check the proper Power Voltage. Do not operate a 12Vdc inflator with a 24 V power
supply.
WARNING
Do not leave the unit running unattended. Over-inflation of items could result in
serious injury.
WARNING
Excessive air pressure may cause a hazardous risk of bursting or personal injury.
Check the manufacturer's maximum pressure rating for items being inflated.
USE of GE 20-2