Important Charging Notes - SCOPREGA GE 20-2 Manual De Instrucciones

Ocultar thumbs Ver también para GE 20-2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

1. Longest life and best performance can be obtained if the battery is charged when the air
temperature is between 18°- 24°C (65°F and 75°F).
DO NOT charge the battery in an air temperature below +40°F (+4.5°C), or above +105°F
(+40.5°C). This is important and will prevent serious damage to the battery.
2. The charger and battery may become warm to touch while charging. This is a normal
condition, and does not indicate a problem.
3. DO NOT immerse charger in water or any other liquid.
WARNING: DO NOT ALLOW ANY LIQUID TO GET INSIDE THE CHARGER.
ELECTRIC SHOCK MAY RESULT
4. DO NOT attempt to charge the battery with any chargers other than the ones in this
manual.
The charger and battery are specifically designed to work together.
5. The charger is not intended for any use other than charging the battery in the Inflator.
Any other uses may result in risk of fire, electric shock or electrocution.
6. Make sure cord is located so that it will not be stepped on tripped over, or otherwise
subjected to damage or stress.
7. Do not operate charger with a damaged cord or plug.
8. Do not operate the charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way.
9. Do not disassemble charger. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
10. Never use another products charger to charge this product. Always use identical
replacement parts only.
11. To operate the inflator insert the fuse, located inside the carry bag, first.
12. Charging time may take up to 8 hours.
13. Fully charge the battery and remove the fuse if the inflator is not used for more than 30 days.
GE 20-2 is a new portable, high efficiency electric Inflator that stands alone for reliability and
function. The GE 20-2 is a twin cylinder, high performance pump able to inflate at any pressure
between 10 and 1500 mbar. The pump starts when the ON push button is pressed and automatically
switches off when the set pressure in the gauge is reached. The OFF button stops the unit when
pressed by operator.
GE 20-2 is fully portable since a battery is included in the unit. In case of battery LOW it is possible
to connect the unit to a cigarette plug or to an external 12V battery via alligator clips.
The unit can be recharged by a 110-240Vac adaptor or by a 12Vdc cigarette plug.
The INLET PORT is protected by a sand filter, the OUTLET PORT is fitted with a CHECK VALVE.
The unit is protected against high temperature. In case of external high temperature conditions or in
case of continuous running, the inflator will automatically stops and a RED Light on the GAUGE will
signal the status. When the RED light will go OFF it will be possible to restart the unit.

IMPORTANT CHARGING NOTES

INTRODUCTION

Publicidad

Tabla de contenido
loading

Tabla de contenido