Mopar XBM Manual Del Usuario página 17

51. If necessary, pull back the I/P insulator to access the
remote start antenna cavity located on top of the I/P
base panel near the driver side.
52. Using the kit supplied antenna (1), route the antenna
harness through the opening in the instrument panel
top near the bottom left edge of the remote start an­
tenna cavity.
53. Place the antenna (2) into the cavity, onto the locating
pins and install the mounting screws (1). Tighten the
screws securely.
54. Route the antenna harness (1) through to the lower
steering column opening.
55. Continue routing the antenna harness (1) behind the
kneeblocker towards the WIN module (2).
56. Disconnect the harness from the WIN module (2) and
discard the original WIN module.
57. Using the kit supplied WIN module (2) , connect the
factory harness (3) and the antenna harness (1) to the
WIN module.
Jul 01, 2011
4280416
17
K6861201