Measurement Mode And Configuration Mode - J.P. SELECTA CD-2004 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80199 REV B
J
.P. SELECTA s.a.
April/2010

6.4 Measurement mode and configuration mode

The equipment can be configured in two different modes:
«Measurement mode»: when the equipment measures conductivity, TDS or salinity.
«Configuration mode»: when the equipment is used for configuration or calibration.
There are some different «states» inside each «mode»:
6.4.1 «Measurement mode» states:
DISPLAY indication
CON
TDS
SALT
COM
PRN
SAVE
OVER
6.4.2 «Configuration mode» states:
Indicators during conductivity configuration.
DISPLAY indication
CONT/ADJS
COEF
CAL/CA-M
Indicators during TDS configuration.
DISPLAY indication
CONT/ADJS
COEF
CAL/CA-M
TCAL/CA-M
TCOE
Indicators during Salinity configuration.
DISPLAY indication
CONT/ADJS
CAL/CA-M
Common parameters to all measurement modes.
DISPLAY indication
PRN/ SURE/ NULL/ PRN-
VIEW/ N001/ NULL/
DEL/ SURE/ DEL-
ASD/ ON/ OFF
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(It can be modified without notice)
Meaning
When measuring conductivity
When measuring TDS
When measuring salinity
When transferring data RS-232
When sending data to the printer
When saving data to memory
When it's out of range
Meaning
Sensor constant selection and adjustment
Temperature compensation coefficient
Sensor constant calibration
Meaning
Sensor constant selection and adjustment
Temperature compensation coefficient
Sensor constant calibration
Transfer coefficient selection and adjustment
Transfer coefficient calibration
Meaning
Sensor constant selection and adjustement
Sensor constant calibration
Meaning
Data printing dialog
Data visualization dialog
Data erase dialog
Equipment automatic stop configuration
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 15