Warn PN 76080 Manual Del Usuario página 5

STEP 2: MOUNT THE RECEIVER
WA R N I N G
The receiver must be correctly installed to work properly. The
receiver should be mounted in a location that is as clean and
TO PREVENT SERIOUS INJURY OR
dry as possible while also allowing access to the
DEATH FROM EXPLOSION:
programming button. The mounting location must also
• Do not drill into gas tank.
provide clearance for the wire harness to attach to the
• Verify the area is clear behind the
receiver.
mounting location before drilling.
Best locations for the receiver will vary depending on the
vehicle. Typical locations include: under dash, on inner
fender inside engine compartment. Avoid mounting receiver
near battery or exhaust manifold. Maximum operating
temperature is 220 F˚ (104˚C).
Mounting Steps:
1. Determine the mounting location.
2. Mount on a flat surface, mark and drill a minimum of two
(2) mounting holes, one on each side of the receiver.
3. Loosely attach the receiver using 1/4-inch or M6 bolts
and locknuts.
4. Tighten fasteners.
Programming LED
Programming button
WA R N I N G
TO AVOID SERIOUS INJURY OR
DEATH FROM ELECTRICAL FIRE:
• Never route electrical
cables:
-Across any sharp edges.
-Through or near moving STEP 3: ROUTE THE HARNESS
parts.
-Near parts that become
Routing Steps:
hot.
1. Plan a route for the wire harness between the receiver and
• Always insulate and
the winch control pack.
protect all exposed wiring
2. Route harness.
and electrical
terminals.
Warn Industries, Inc.
6
Minimum of one fastener on each side
STEP 4: CONNECT THE WIRING
WA R N I N G
Note: Refer to Figure 1.
TO AVOID SERIOUS INJURY OR
1. Connect the wire harness to the receiver.
DEATH FROM ELECTRICAL FIRE:
2. Connect the 90 degree plug on the wire harness into the
• Never route electrical
winch control pack.
cables:
3. Use tie wraps to secure the wire harness.
-Across any sharp edges.
-Through or near moving
parts.
-Near parts that become
hot.
• Always insulate and
protect all exposed wiring
and electrical
terminals.
Figure 1: Wiring Installation Diagram
WARN Wireless Control Installation Guide 7