HAMPTON BAY 52389 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring from the canopy (C) by turning the
ring to the right until it unlocks.
□
Remove the mounting plate (A) from the canopy by
loosening the four screws on the top of the canopy (C).
□
Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting bracket
(A).
3
Assembling the fan
□
Loosen, but do not remove, the setscrew (FF) on the collar
on top of the motor housing (D).
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar on top of the motor housing (D).
□
Carefully insert the hanger pin (CC) through the holes in the
collar and downrod (B). Be careful not to jam the hanger pin
(CC) against the wiring inside the downrod (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Re-tighten the setscrews on the collar on top of the motor
housing (D).
2
Routing the wires
□
Route the wires exiting the top of the fan motor (D) into
the decorative motor collar cover (F) and through the
canopy ring.
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
A
C
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
B
F
D
F
DD
B
FF
D
HAMPTONBAY.COM