HAMPTON BAY 52389 Guía De Uso Y Mantenimiento página 8

Assembly - Hanging the Fan
4
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to outlet box marked
"Acceptable for fan support of 35lbs. (15.9 Kg) or
less", and use screws provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting plate on the outlet box by sliding the
mounting bracket (A) over the two mounting screws (GG) provided
with the outlet box. If necessary, use leveling washers (not
included) between the mounting bracket (A) and the outlet box.
Note that the flat side of the mounting bracket (A) is toward the
outlet box.
□
Securely tighten the two mounting screws (GG).
GG
5
Hanging the fan
□
Carefully lift the fan motor assembly (D) up to the mounting
bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
mounting bracket (A) socket is properly seated in the groove
in the hanger ball.
GG
A
A
B
D
6
Setting the remote control codes
NOTE: The frequencies on your receiver and remote control have
been preset at the factory. Before installing the receiver, make
sure the dip switches on the receiver and remote control are set
to the same frequency. The dip switches on the remote control
are located inside the battery compartment.
NOTE: This remote is equipped with a 16-code combination.
To prevent possible interference from or to other remote units,
such as garage door openers, car alarms or security systems,
change the combination code, but be sure that the code on
both the hand held transmitter and receiver in the fan are the
same.
To set the code on the remote control:
□
Remove the battery cover by pressing firmly on the arrow
and sliding the cover off.
□
Slide the code switches to your choice of either up or down.
The factory setting is up.
To set the code on the receiver:
□
Slide the code switches to the same position as set on your
transmitter.
□
Replace the battery cover on the transmitter.
Controller Model: UC7067RYK
ON
1 2 3 4
8
ON
1 2 3 4